Description

Requirements of materials for lithography at 193 am limit single layer resist candidates to those with high optical transmission. A random copolymer of trimethylsilymethyl methacrylate (SI) and chloromethyl styrene (CMS), [P(SI-CMS)], has been shown to be highly sensitive negative 193 nm resist in both bi-layer and single layer modes. Such resists show maximum sensitivity with an optical absorbance of the coating oflog10e, or 0.434. Through control of the mole ratio of the monomers in the P(SI-CMS) copolymer, absorbance values have been optimized for film thicknesses of0.2 - 0.3 micrometers for 90: 10 SI:CMS, 0.35 - 0.45 m for 95:5 SI:CMS and 0.55 -0.65 pm for 98:2 SI:CMS. Optical absorbance ofthe CMS is at a maximum in the 190 to 205 nm range, allowing the copolymer to be tailored for a large degree of crosslinking at a relatively low CMS concentration. Spray development of these materials is performed with ethanol, followed by a two step methanol I isopropanol-water rinse. Sensitivities are on the order of 4 to 20 mj/cm^2 at M near 40 000 g/mol. Furthermore, these ratios have been found to produce optimum 02 etch resistance.

Date of creation, presentation, or exhibit

1995

Comments

Copyright 1995 Society of Photo-Optical Instrumentation Engineers. One print or electronic copy may be made for personal use only. Systematic reproduction and distribution, duplication of any material in this paper for a fee or for commercial purposes, or modification of the content of the paper are prohibited.

Note: imported from RIT’s Digital Media Library running on DSpace to RIT Scholar Works in February 2014.

Document Type

Conference Paper

Department, Program, or Center

Microelectronic Engineering (KGCOE)

Campus

RIT – Main Campus

Share

COinS